XTS-2500 Help

[yardbirdjr]

Hello

I need some answers and help!!

I have a XTS-2500 and according to the radio when I place it in test mode it says it has a 700/800 RF board.

Well I can't seem to program any 700 Mhz. channels in the thing.

All I keep getting is the red error box around the frequency when I enter them.

The 800 Mhz. stuff will program fine without any problems.

Just curious to see if there is an issue with the radio or if I am not doing some thing right.

Please let me know,

Thanks

David

[MTS2000des]

change the channel bandwidth to 2.5KHz

[yardbirdjr]

I will try it

Thanks

David

[mikegilbert]

You also may have an XTS2500RB model, which is limited to 800mhz only. If you post the model #, flashcode and host/dsp, we could get a better idea of the issue.

[yardbirdjr]

Mike,

Please check your PM's

David

[yardbirdjr]

Mike,

Her is the information on the radio that I PM'ED you about

XTS-2500

Model: H46UCF9PW6BN
Flash: 581018-10168C9
Host: R19.50.00
DSP: R19.50.00

Hope this helps

David

[Java]

So did the 2.5khz help the OP get his radio down to 700mhz?

[yardbirdjr]

I messed with a little.

Please advise where I need to go to change this

David

[mikegilbert]

The 2.5khz should be under "TX deviation" on the zone channel assignment screen.