Page 1 of 1
NTN1340C
Posted: Thu Jan 19, 2012 10:26 am
by taylorfarms
This is a stupid question i i am wanting to use the cradle only to charge and store mt mt200 when using on a module builder. Is this possible, and would also like to uc=se the external speaker and mic whne in the cradle. I dont have the amp for this . doable or not. Thanks michael
Re: NTN1340C
Posted: Thu Jan 19, 2012 8:00 pm
by d119
Er, uh... What?
Re: NTN1340C
Posted: Fri Jan 20, 2012 6:00 am
by fineshot1
taylorfarms wrote:This is a stupid question i i am wanting to use the cradle only to charge and store mt mt200 when using on a module builder. Is this possible, and would also like to uc=se the external speaker and mic whne in the cradle. I dont have the amp for this . doable or not. Thanks michael
At the minimum you would need the NTN1322 - basic control unit and NKN6453 - interface cable
to make that work for you.
The control unit has the charging and audio amp electronics and the holder unit you have
is only just that a holder cradle for portable.