Batboard

have 2 milcom 100w repeater amp boards and want to put them together to make 1 200w but can not find any info on milcom and what kind of keying circuit they used or what class c,ab or both this is my first real project that i have to build something from nothing and before i look at a pic and told what resistor to pull and replace with a different value.PLEASE any help i will be very grateful .

thank you

Milcom? Do you mean Micom? Otherwise a picture might start the ball rolling...

Milcom... TPL

how do i post pics ?

Vocom became Crescend, Crescend then acquired Milcom which i think was part of Powerwave.

See link below

http://www.crescendtech.com/about.html? ... 31669397f7

Anyway combining those two amps together to give you a full 200W output will be tricky.

I don't think you would get a full 200W. You would need some kind of combiner that will
keep them both in phase. You may want to keep an eye out for some of those older
Milcom amps on ebay that have been stripped of amp stages with the combiners still
intact in the amp cabinet.

do you know any model #'s that could give me a clue of what to look for

ke5aqt wrote:do you know any model #'s that could give me a clue of what to look for

Sorry - that is not the kind of info I keep track of but they will be
similar to the ebay item number: 200589442670 and 200589176382
that are for sale now. Ebay may be your only source as I don't know
where else to seek them.