Page 1 of 1
Quick Call II Tones XTS 2500
Posted: Thu Feb 09, 2012 3:14 pm
by rmidle0095
How do I add fire pager tones using quick call to a personality? WHat setting do I need enabled and so on. I have one ch I want fire tones on. Its two sets of tones for two citys that use the same mutual aid. I want the radio to alert me when it goes off for that tone. Basically what a fire pager does. XTS 2500I
Thanks
Re: Quick Call II Tones XTS 2500
Posted: Thu Feb 09, 2012 4:47 pm
by HLA
first off, is your radio flashed for qcII?
Re: Quick Call II Tones XTS 2500
Posted: Thu Feb 09, 2012 4:55 pm
by rmidle0095
Yes it is. Its a 2500I. Here is the info from the CPS
Flashcode
5A1018-10178C-5
What other info do you need to make sure?
Re: Quick Call II Tones XTS 2500
Posted: Fri Feb 10, 2012 11:46 am
by jmr061
Better question is what firmware is in the radio. QCII didn't get supported until later on. Then we can go from there.
Jason
Re: Quick Call II Tones XTS 2500
Posted: Fri Feb 10, 2012 1:43 pm
by rmidle0095
info from radio
HOST R15.00.08
DSP R15.00.05
8MB
I hope this is what is needed.
Re: Quick Call II Tones XTS 2500
Posted: Sat Feb 18, 2012 7:13 am
by rmidle0095
bump......