Page 1 of 1
Flashcode Option to show MDC1200 ID on XTS5000 MODEL II
Posted: Thu Mar 08, 2012 9:05 am
by 4-crime
Hi all, I was wondering if anyone knows the exact flashcode option that is needed to have MDC1200 ID's to show up on the screen of my XTS5000 Model II. Now My radio has H14 Enhanced Digital ID Display in the flashcode and when recieving digital audio the keyed up radio's ID shows up just fine. But on conventional analog point to point I do not see the ID's pop up on the screen. Now on my XTS5000 Model III I do see it. So I am sure it is just a flashcode option that I need in the radio, i'm just not sure which one. Any help you guys can give is much appreciated.
Re: Flashcode Option to show MDC1200 ID on XTS5000 MODEL II
Posted: Thu Mar 08, 2012 9:33 am
by jmr061
Its a programming issue not a flashcode problem. You already have the required flash.
Jason
Re: Flashcode Option to show MDC1200 ID on XTS5000 MODEL II
Posted: Thu Mar 08, 2012 2:38 pm
by 4-crime
Ohh, ok...any ideas as to what I am NOT doing corectly in the CPS?
Re: Flashcode Option to show MDC1200 ID on XTS5000 MODEL II
Posted: Thu Mar 08, 2012 5:15 pm
by jmr061
Do you have an MDC profile assigned to the channels in question?
Jason
Re: Flashcode Option to show MDC1200 ID on XTS5000 MODEL II
Posted: Sat Mar 10, 2012 12:23 am
by 4-crime
I got it figured out. I just had to adjust the amount of time the ID displays on the radio's screen under the PTT-ID setting in the CPS. It was set to 0 seconds.