Batboard

Has anybody with an R2600 had a power up problem that they fixed? My R2600 has been getting funny in the last few month's where it will power on, but it won't go through the start up calibration until the 3rd or 4th time you turn the power switch off and back on. Then it would run through the initial set up and be good to go. Now it won't come on at all. I can hear the relay click when I plug the unit into a 110 outlet, but the unit display will not come on at all. Any suggestions? Thanks in advance.

Ed Delahanty
KF7MEG
New Smyrna Beach, Fl

sounds like the caps on the power supply are shot... replace all the electrlytics with low esr caps.happened to my 2590... solved the problem

Thankyou very much CircleBat.

Ed