Batboard

Here's the deal, I have a ht1000 w/ dtmf that had some sand stuck around the DTMF pad buttons. I decided to crack the case to clean things up anyways as i was getting in to disconnect the front ribbon cable the cable tore at the connector. Errrr!!
My question is can I order just a new cable? Where would you guys recommend getting it from? Also how would you go about desoldering the dtmf board, and soldering the new one onto the replaceable cable?
Thanks in advance.

I have a good used front with all the flex and keypad for $45 shipped if you want ot go that route

Thanks for the quick reply. Does anyone have a flex they would be willing to sell?
Thanks again, this place is full of good people and lots of great info.

And thanks firecpt for the offer, but with how cheap these radios are becoming on eBay I might just buy a replacement radio.

Got it Fixed.