Page 1 of 1
HT600 speaker mics
Posted: Thu Jul 05, 2012 10:38 pm
by malblast
I have some old HT600 speaker mics ( NMN6156A ). Has anyone been able to replace the cords and have them work on the two pin connection like a CP200 ?
Re: HT600 speaker mics
Posted: Fri Jul 06, 2012 5:58 pm
by CircleBat
they usually break at the bottom ontop of the strain relief.. usually cut it off and reconnect it.. not worth replacing the cords.. Might have some new old stock cords if interested..
circleBat
Re: HT600 speaker mics
Posted: Mon Jul 09, 2012 8:56 am
by JMINN
It can be done. As I recall you will need to modify the spkmic circuit board. compare the two spk mic circuits and you will see the difference.
Joe
Re: HT600 speaker mics
Posted: Mon Jul 09, 2012 3:12 pm
by CircleBat
cp200/Ht600 cords are 2 different types of cords.. gp300 = 4 wire while HT600 = 6 wires
Re: HT600 speaker mics
Posted: Mon Jul 09, 2012 3:12 pm
by CircleBat
cp200/Ht600 cords are 2 different types of cords.. gp300 = 4 wire while HT600 = 6 wires