Batboard

Hi all,

Just tuned up a UHF MSR2000, Everything is working great except one thing, the Transmitter stays ON until it receives a signal, then it shuts off... Then when the signal goes away, it turns on... 100% backwards..

I can't for the life of me figure out why it's doing this... Must be a jumper someplace. Anyone know where?

Thanks

Glen
VE9GLN

I'm assuming no external controller?

My first guess would be something non-standard/hamhacked done on the Squelch Gate card. Got another one you can swap out?

Yes, I have one other, unfortunately it doesn't do squat, as in either way

No, no external controller.... though is this keeps up...I might do so.

It's going to be going up as a HUB repeater on a somewhat inaccessible mountain, so I wanted to keep it very simple.

Glen
VE9GLN

Take a look at the "backwards" squelch gate card vs. the one that doesn't do anything. Make sure the jumpers on the non-working unit are set identically to the "backwards" unit. This at least gives you a benchmark starting point...