Batboard

All,

I have 2 CDM1250 radios I am setting up for 2-Tone encode. I am familiar with programming these radios and how to set up the Quick Call system, Call Alert settings, Call List, Assign buttons, everything associated with making this work. I have written the same codeplug to both radios.

The problem is one of the radios will work fine. The other one does nothing. I am using a button assigned to the Call Alert function instead of doing it through the menu. On the radio that will not encode, I tried re-assigning the Call Alert function as a long button press vs. short press and even moved the function to another button on the radio thinking that there was some kind of physical problem with the button. No matter what button I assign the Call Alert function to, it does nothing when pressed. No beep of any kind. All other functions work as normal.

I will have to look to make sure but I am thinking one radio is a 2000 model and the other is 2003. Also if i recall they have different firmware versions. I will look at them again and confirm this.

Any suggestions?

Thanks,

Wes

what's the model number of the radio you can't get to work

HLA wrote:what's the model number of the radio you can't get to work

Both radios have the same model number: AAM25KKD9AA2AN

Wes

Ok then next question is firmware versions? the 1250's were always capable of encoding. So what happens when you try to clone the working one into the non working one?

I'll have to get the firmware version. As far as cloning goes, they both accept the same codeplug.

if they both take the same codeplug i'd be looking more at firmware, update both radios to the newest if you can

That CDM with the 2000 date may have the dreaded 1.0.x firmware which had all kinds of wackiness associated with it.

Update:

I have been acquiring the needed hardware and software to upgrade the firmware in the radio. I am now ready to proceed and upon reading the radio to save a codeplug before the upgrade I find that the current firmware is already R05.04.00.

Should this problem be occurring with firmware this current?

If both radios can encode and decode 2-Tone, then I would look at your settings to ensure they match.
Are both tones identical for both radios?
Is your numbering system legitimate, like in QC-II, you have specific numbers associated to each tone.
IE....433.7 is 115 Etc...
All things being equal, there has to be a discrepany located somewhere in your configuration if it is not working.

AEC,

The problem is that when you assign Call Alert Encode to any button on the radio, that button does nothing. The one radio works fine, the other does not. Both radios have been written with the same .cpg file. Ive tried assigning the Call Alert function to different buttons on the radio and that makes no difference. Today I was going to do a firmware upgrade but after installing the upgrade kit on my PC, I was unsuccessful because the program kept crashing. See pic:



I installed this upgrade software on 2 different pc's. One was running XP and the other running 98 and both yielded the same results. The software opens fine and as soon as you click the Program button the error pops up and the software shuts down.

Anyone have any suggestions?

Wes

you have something else running that the upgrade tool does not like. All of the runtime files needed for that program are in the install. Did you get a pop up telling you that what you have is newer than the one being installed? but 5.04 can definately encode and decode, I don't know that 5.10 will gain you anything but it's always worth a try. The 5.10 tool will definately run on xp

No popups.......

After seeing what firmware is in the radio, I am not sure a firmware upgrade will do me any good on this problem unless what is in there now has a corrupt bit somewhere causing this exact problem. I think if it was corrupt it would be having other issues though.......