Page 1 of 1
CPS XPR 7550 Question
Posted: Tue Oct 16, 2012 8:27 pm
by ces911
I asked on another forum, I wanted to double check...
Can you program the new XPR 7550 with the XPR 6550 software, the newest version of SW is 8.0.. I ordered the XPR 7550 and want to make sure , so i can program as soon as i get with out delay..
Thank you
Re: CPS XPR 7550 Question
Posted: Tue Oct 16, 2012 11:07 pm
by mr.syntrx
Yes.
Re: CPS XPR 7550 Question
Posted: Fri Oct 26, 2012 12:03 pm
by com501
You WILL NEED the B series cable....
Re: CPS XPR 7550 Question
Posted: Fri Oct 26, 2012 2:18 pm
by N4KVE
com501 wrote:You WILL NEED the B series cable....
An "A" series cable can be converted to a "B" series cable in about 5 minutes. I've tried to post the mod here, but can't. Please e-mail me if you need this mod. GARY
Re: CPS XPR 7550 Question
Posted: Fri Oct 26, 2012 2:59 pm
by com501
I tried the mod, it didn't work with my cable when I tried to program a 6550. It did work with the one wire driver and the 7550. It's cheaper just to buy factory cables.
Re: CPS XPR 7550 Question
Posted: Fri Oct 26, 2012 3:59 pm
by N4KVE
I haven't done the mod, as I only have a 6550. I figured I'd do it if & when I bought a 7550. So your "A" cable which used to program your 6550 no longer does since you did the mod? If so, please contact me so I can send you the mod, & tell me if that's the same mod you did. My friend who sent me the mod swears it works for him using the factory "A" cable. Thanks. GARY