Page 1 of 1
CM200 Software Question
Posted: Wed Jan 02, 2013 8:12 pm
by Tron
Just received the latest update for the CM200 software. My question is, do you just load in the updated program and it over writes what is needs to, or should you uninstall the existing program and then install the updated one? There is no guidance with enclosed "instruction" sheet.
Tron
Re: CM200 Software Question
Posted: Wed Jan 02, 2013 10:57 pm
by SteveC0625
Tron wrote:Just received the latest update for the CM200 software. My question is, do you just load in the updated program and it over writes what is needs to, or should you uninstall the existing program and then install the updated one? There is no guidance with enclosed "instruction" sheet.
Tron
Just install it. It will overwrite as necessary and keep any code plugs that you have already created.
Re: CM200 Software Question
Posted: Thu Jan 03, 2013 7:35 am
by Tron
OK, thanks.
Tron
Re: CM200 Software Question
Posted: Fri Jan 04, 2013 11:42 am
by Will
The newer versions coming from Motorola all have the wide band, 5K and 4K deviation locked out.
Most say NOT to upgrade your CPS. due to this forced narrowbanding. No one at /\/\ is considering the other services, Part95 and 97 ham.
Re: CM200 Software Question
Posted: Mon Jan 07, 2013 5:53 pm
by HLA
I havn't updates software lately to see that yet but that probablly means they will also write it into the firmware too?
Re: CM200 Software Question
Posted: Mon Jan 07, 2013 6:44 pm
by Tron
Thanks for your message on the narrow band only as I was getting ready to install it. Whew! We'll let well enough alone for now as these type of "improvements" I don't need.
Tron