XTS5000 Commander II power-up audio
Posted: Thu Feb 28, 2013 8:25 pm
Hello - I have an XTS5000 running channel announcements, with which I use a Commander II mic. The problem I am having is that when I turn the radio on, the channel announcement emits from the radio's speaker. Then the radio "sees" the mic and the announcement is played again via the mic itself.
Is there a way to stop the announcement from happening until the mic has "seen" the radio? It's not the end of the world, but hearing the channel name spoken twice every time I turn the radio on gets annoying.
My firmware version is 19.00.00 and the power-up alert tone is disabled.
Thanks!
Is there a way to stop the announcement from happening until the mic has "seen" the radio? It's not the end of the world, but hearing the channel name spoken twice every time I turn the radio on gets annoying.
My firmware version is 19.00.00 and the power-up alert tone is disabled.
Thanks!