Zetron 4000 Series Prog Cable

[kf8yk]

Anyone have the pinout for a Zetron channel monitor programming cable p/n 709-7452?

This is a RS232 serial cable that plugs into the 5 pin monitor port of a Universal Dual Channel Card in the 4000 series common control rack.

Thanks.

[Jim202]

Anyone have the pinout for a Zetron channel monitor programming cable p/n 709-7452?

This is a RS232 serial cable that plugs into the 5 pin monitor port of a Universal Dual Channel Card in the 4000 series common control rack.

Thanks.

I want to say it is a standard serial cable. But your best bet is to call Zerton and get the answer right from the horses mouth.

Jim

[MassFD]

I think he is looking for the cable that plugs into the pins on the front of the 2 channel cards, I have 1 in the shop that I made using the pinout in the Zetron manual then I found the one that shiped with the system.

I will not be back in the shop till Tuesday and will look at what I have unless someone answers sooner

[MassFD]

Sorry for the delay

cable from the Zetron chanel card Monitor port is as follows

Starting from the top (call it pin 1)
Zetron Pin 1 not connected
Zetron Pin 2 not connected
Zetron Pin 3 to db-9 Pin 2 (rx data)
Zetron Pin 4 to db-9 Pin 3 (tx data)
Zetron Pin 5 to db-9 Pin 5 (sig gnd)
Pin 5 being the bottom pin

Using Hyperterm at 19200 8 - N - 1 pressing the reset button on the chanel card should get you a listing of the cards data

[kf8yk]

That works, thank you.