Page 1 of 1
APX 7000 channel selector knob swap-out
Posted: Fri Mar 22, 2013 6:03 pm
by sjxts3000
OK, so I picked up one of the "fat" APX 7000 knobs, but I'm reluctant to destroy the "tiny" one off my radio without knowing if this new "fat" OEM knob is just a direct swap. If the tiny knob is removed, the fat one looks like it might not go all the way "down" the stem. Is there something I'm missing? Anyone swapped one of these out before?
Re: APX 7000 channel selector knob swap-out
Posted: Fri Mar 22, 2013 7:11 pm
by Mfire39
Pull the tiny one off, and push the fat one on.. Easy as that.
-Marc
Re: APX 7000 channel selector knob swap-out
Posted: Fri Mar 22, 2013 7:28 pm
by sjxts3000
Mfire39 wrote:Pull the tiny one off, and push the fat one on.. Easy as that.
-Marc
Dang...that *was* easy! I just did it in 10 seconds. Thanks for the confirmation. I just wasn't sure if the new one slid all the way down or not. Didn't even need any pliers (can't recall who said pliers, but they are not needed).
Thanks!
Re: APX 7000 channel selector knob swap-out
Posted: Sat Mar 30, 2013 9:30 pm
by batmoto
Anyone know the part# for the fat knob?
Re: APX 7000 channel selector knob swap-out
Posted: Wed Jul 24, 2013 5:13 pm
by loband
Part number 3675590B02