Batboard

I am confused as to the CWID "TX interval" and "Mixed mode timer" operation of the MTR3000 conventional programing. I had both enabled on a station. The "TX interval" was set @15min and the "Mixed mode timer" @20min, the customer complained that they were hearing CWID in their conversations.

Should I only set the "TX interval" @15min which I beleive is the part 90 requirement for bussiness users and set the "Mixed mode timer" @255min which will dissable it? will that stop the customer complaint of the possibility of having CWID mixed in their communications?

Thanks!

You could just leave the timers where they are at and check the box to strip the PL from CWID...

escomm wrote:You could just leave the timers where they are at and check the box to strip the PL from CWID...

I did have the box checked to strip PL. But the fleet has the monitor button enabled and also off hook monitor which all might have to change.