Page 1 of 1
IP Site Connect
Posted: Wed Aug 14, 2013 4:25 pm
by CircleBat
Have 2 questions
1) When 2 turbo are linked together and have analog detect enabled on the repeaters, when the repeater detects an analog signal, will 2 both repeaters revert into anolog mode and transmit simultaneously? or just 1 repeater
2) Are the turbo IP Site connect repeaters both easy to configure so that when one repeater detects a signal , the other comes up at the same time? Any other configurations required on the portables?
greatly appreciate your help as I have a project linking 2 sites together using digital and analog detect
CircleBat
Re: IP Site Connect
Posted: Wed Aug 14, 2013 4:30 pm
by Josh
From what I recall... IP Site connect isn't even an option on a mixed-mode repeater.
inter-networking of repeaters is a digital only system.
Re: IP Site Connect
Posted: Wed Aug 14, 2013 7:12 pm
by TreyH
Josh is correct in that dynamic mixed mode (analog) is not an option when utilizing IP Site Connect. You might try googling "MotoTrbo System Planner". It's a Motorola publication explaining most all the MotoTrbo features.
Re: IP Site Connect
Posted: Wed Sep 18, 2013 11:39 am
by Ali Abbassi
Dynamic mixed mode is not an standard feature it can be purchase as an option for Mototrbo Repeater, it works for a single repeater only but not for two repeaters linked via Ethernet in IP site connect mode .
Re: IP Site Connect
Posted: Wed Dec 04, 2013 3:13 am
by moztas
Ali Abbassi wrote:Dynamic mixed mode is not an standard feature it can be purchase as an option for Mototrbo Repeater, it works for a single repeater only but not for two repeaters linked via Ethernet in IP site connect mode .
"Dymamic Mixed Mode" is a free and standard option for repeaters.
System Planner explains that:
Dynamic Mixed Mode
does not support the following configurations/features.
• IP Site Connect configuration
• Capacity Plus configuration
• FCC Type-I and Type-II monitoring
• Transmit Interrupt feature
• RDAC over IP feature
• Repeater Knockdown
• PTT on a 4-wire interface
Re: IP Site Connect
Posted: Wed Dec 04, 2013 3:42 am
by wavetar
moztas wrote:
"Dymamic Mixed Mode" is a free and standard option for repeaters.
No, it is not. You must enable it via Entitlement ID procedure. I believe the cost is $210...but I don't have the price book in front of me right now.
If you mean the repeater is capable of analog OR digital right out of the box, you would be right. But it's not dynamic.