Batboard

I have an HT1250 that only puts out between 1 and .75 watts. The longer I hold the PTT the lower the power goes.

I am guessing that the PA is bad. Is there a way to test if it is bad? If not, does anybody have any suggestions.

I am willing to pay to have it fixed, or would be willing to purchase another HT1250 circuit board.

Regards,

Chris Andrist, KC7WSU

is it set on high power or low power.. sounds like a battery issue to me

CircleBat

I think I have tried it with several different batteries, but I am not sure. I will try all of my batteries and put it on the service monitor again and report back.

Regards,

Chris Andrist, KC7WSU