Batboard

I bought a HT1250 LS+ off someone for 10 bucks because they put a standard HT1250 Codeplug for the same range and all into it and could not get it to receive. I have a friend with a subscription to the CPS and he lets me use it to program channels but all i hear is like a faint white noise always even if i open the squelch. the seller said he put a codeplug from a newer software into it and tried to program the new software in but programming the software was a failure.

The radio's orginal codeplug is for AAH25RDH9DP6AN Version number:R05.13.04 Range 403mhz-470mhz

The one the seller threw in was AAH25RDH9AA6AN of unknown Radio software I just know its higher.
If anyone can help i am even willing to ship it out to just keep the standard 128 channels version. I got told by the local seller they would not touch it at all even to redo the radio with its original codeplug.

Thanks
BlackJack

Very likely you have to retune the radio.
Reflashing to a different version wipes out all the softpot values.
Try running Radio Tuner on it.
You should use a proper service monitor and a battery eliminator to do so.

Alfred.

I do not know how to tune and i do not have the money to go out and buy more equipment to fix this. I have the tuning file on a cd from the guy but after a few hours of reading that i need a different tuner to change the serial number and i can not find it i am resorting to this.

Issue resolved it did not need tuning...I know it does need it period....It was not a Full Keypad Codeplug the guy used. I was able to get the right codeplug in it...all 128 conventional channels.