Batboard

Hi,
I am a recording engineer. How could I wire the RMN5068 for use with "line level" audio, like using a Shure SM57 into a microphone preamplifier? Would I use a balanced XLR connection or unbalanced TS? What wires, etc?

I believe the ohms should end up being in the 300-600 ohms going into a microphone preamplifier. But do these mics have their own preamp?

Also, is there any difference in audio quality between the RMN5068 and the RMN5068A? The A seems half the price. I've heard hese mics have a cool effect and sound when recorded as opposed to a "normal" studio mic...

Thanks guys/gals!
Billy B

The RMN5068/A are just the same mic from back in the Mocom 70 Consolete days, with different wiring.

I never liked the very poor acoustics and poor sound quality of these mics. Just a electret element and one stage amp.

They do require a DC feed thru a 560 ohm resistor from 8 volts DC to operate the internal amplifier. Output is 180 MV.