Batboard

Greetings,

I am new to the MTR2000 having upgraded from smaller desktop Motorola machines. I am starting to work my way through the RSS and have been able to get the radio programmed as to frequency and PL tone. I was wondering what needs to be done as far as receiver/transceiver alignment?? The repeater seems kinda deaf to the ear without taking any measurements.

Any thoughts from those with experience with the MTR2000 would be appreciated.

Thanks in advance!!

Doug
"[email protected]"

first, read over these pages on the MTR:

http://www.repeater-builder.com/motorol ... index.html

Tuning is all done in MTR2000 RSS. It's actually very straightforward.

Remember these stations are designed around a "field replacement strategy", when a fail occurs, you replace a module.

I have one in service myself.

Also if it has the preselector installed they are only 4 megs wide, you may need to re tune it.

Jim

do not get in the habit of "reading - changing - writing" the codeplug. From the mouth of mother M "make your changes on a codeplug from the stock template in the RSS - and write a known good codeplug"