Page 1 of 1
Posted: Fri Nov 16, 2001 1:47 pm
by tarekennedy
I have two ribs one from barnwell and one from radiostew. I am having problems with the motorola software in particular 1225 recognizing it attached to the com port or seeing it is there some special way my com port hast to be set or?????
Please Help
Tare kennedy
Posted: Sun Dec 02, 2001 7:34 pm
by PCSAR4x4652
are you using "M" cables or homemade cables?
i had the same problem untill i did a continuity check on each pin on the pc to rib cable and found that 2 wires were crossed. after swapping the 2 it worked fine.
also, if the battery is dying or the radio and rib are not "on" you may get that error, too.
_________________
Todd Freeman
Pierce Co Sheriff Dept. SAR
<font size=-1>[ This Message was edited by: PCSAR4x4652 on 2001-12-02 22:35 ]</font>