Batboard

Hello All,

I have an issue with an IPSC system. I have 4 repeaters in the system now, with the original 3 working flawlessly. When I added the 4th repeater, it will only get traffic from the system, and send traffic that is rx'd to two of the three existing repeaters. All the port settings are identical, so I am not certain what might be causing the problem? Has anyone ever seen this happen before.

Thanks, Rob

Firmware versions in each repeater?

Ok, you caught me there. I was planning an update once we do the EID for RAS. I'm a bit lazy sometimes.

Master Repeater : 01.07.02
New Repeater just added : 01.06.11
Repeater new repeater doesn't like to talk to: 01.04.01
East Repeater : 02.30.02

Rob

Repeater new repeater doesn't like to talk to: 01.04.01

This is older than dirt

Off I go to do f/w bumps. Thx for the heads up, rob

F/W issue it were, thanks all.