Batboard

I had a bad PA on my tx brick and had swapped it a few months ago with the RX brick and reprogrammed and worked fine till it took a dump. I purchased a new Brick from Moto. I installed it and couldn't get it to write with CPS. I assume that it was because the different Firmware between the receiver and transmitter. I put back in the old transmitter and now when it boots up the disabled light flashes a few times then no other lights will light and it will not do anything. I can read and write with CPS and the programming is correct, Any ideas?

Chris
W8CTC

Follow the procedure in the manual.