Page 1 of 1
HMN9052C Microphone pin out
Posted: Tue Dec 30, 2014 1:09 pm
by shanebohannan
I am trying to convert a HMN9052C handheld Microphone to an 8 pin kenwood and can not find the pin outs for the mic on the internet.
Can someone point me in the right direction for the pin out.
Thank you
Shane
Re: HMN9052C Microphone pin out
Posted: Tue Dec 30, 2014 7:24 pm
by escomm
Re: HMN9052C Microphone pin out
Posted: Wed Dec 31, 2014 3:59 am
by shanebohannan
That would be it, but I have another question.
Does anyone know what colors go to what pin? Someone (me) cut the end off and now I can't find it to mate the colors to the pin.
Thank you
Shane
Re: HMN9052C Microphone pin out
Posted: Wed Dec 31, 2014 8:21 am
by escomm
Easy peasy. Get a multimeter and ohm them out.
Re: HMN9052C Microphone pin out
Posted: Wed Dec 31, 2014 9:35 am
by RFguy
Motorola uses carbon equivalent and Kenwood uses dynamic (or used to).
Re: HMN9052C Microphone pin out
Posted: Wed Dec 31, 2014 12:08 pm
by Will
Similar to my interface for a Motorola GM300 mic on a ICOM-7200 HF radio... two resistors.
