Batboard

Hi all,

I have a GM 1200, M01RFN9CK8CN, how can I switch to conventional? When I press the Personality Selection Button it toggles between the personalities but it does not go to Conventional (as stated in the User Manual on page 14). I have 2 channels programmed in the Conventional Personality Data (Edit/Common/Conventional Personality Data)?. Any ideas?

Thank you,

Cornel

Normally i just hold the button in til it goes in conventional mode. If you just Press it short, i Think it just toggles betjene the trunked personalityes.
Kind regards Jens