Page 1 of 1
Centracom II BLN6654D JUMPERS
Posted: Sun Jan 25, 2015 6:14 pm
by miken8eqd
Hello,
I have a BLN6654D board in one of the card slots. I do not have a manual for this card so would it be possible to get a list of the jumpers on this card?
Thanks
Mike W8VPC
Re: Centracom II BLN6654D JUMPERS
Posted: Mon Jan 26, 2015 8:36 pm
by The Pager Geek
Anything specific?
Re: Centracom II BLN6654D JUMPERS
Posted: Sat Jan 31, 2015 6:51 pm
by miken8eqd
Well,
Applicaion is interfacing a echolink node through a tone remote that is connected to this module.
I took another look at the board and found JU33 Squeltch enable/disable. It was enabled so i'm going to try that and see if that will make it work
thanks
mike w8vpc
Re: Centracom II BLN6654D JUMPERS
Posted: Tue Feb 03, 2015 11:13 am
by d119
What exactly are you wanting the interface to do?
The BLN6654D Base Interface Module (BIM) is just a 600-ohm in/out interface with tone keying (or DC with a daughtercard)...
Re: Centracom II BLN6654D JUMPERS
Posted: Sun Feb 08, 2015 6:24 pm
by miken8eqd
What was happening was the audio would mute if another station's audio was weak.
JU33 was labeld Squelch and it was enabled. so i changed the jumper from enable to disable. So now if audio was weak, it will not mute.
Since there is no "radio" connected to this card, squelch is not needed.
thanks