Batboard

Hey all,
Can anyone provide me with a Moto Part number for the flat control cable that goes between my CDM Control head and the radio? I think there are 2 lengths.
I believe they were quite reasonable so I wont bother to make them.
Thanks.

GM Gig, I think this is what you are looking for.

3 meters long RKN4077
5 meters long RKN4078
7 meters long RKN4079

And a good morning to you too!!

Good to hear from you.....
thanks for the information.
I have to call MOL this morning... I cant get into my acct... More on that later... thanks again

I believe a straight ethernet cable will work if you don't plan on needing handset audio.

Is there a schematic of the remote kit available? I've never seen one. I'm sure it's not the same pinout as the front mic connector.

ve3nsv wrote:I believe a straight ethernet cable will work if you don't plan on needing handset audio.

Thanks for the reply.
I was told that the connectors on the ends are NOT standard. I was told that they are 10 pin. Believe it or not a local shop had the cables in stock and just a few dollars over MOL... this time I'll just pick them up and be done with it.

RFguy wrote:Is there a schematic of the remote kit available? I've never seen one. I'm sure it's not the same pinout as the front mic connector.

I wish I could help you. I have no idea where to look. When you take a CDM and make it a 2 piece radio.. it's like assembling a Plastic model(minus the Testors red label remember that stuff?) and once everything SNAPS together... it's hard to pry everything apart again- like if you want to go BACK to a one piece radio.