XTS2500 frequencies getting scrambled when programming
Posted: Tue Mar 03, 2015 7:58 am
We just inherited 24 radios from a Fire District my city annexed and had to program them to match our city channel list. Of course they're a different model so can't clone. We did the drag and drop to copy from one of our city radios, and added individual MDC id's, then programmed them. Tried a couple after programming them all, and found that all the TX frequencies in the first zone had been "randomized". None of them matched what they should have been, and they weren't just shuffled around either (like channel 1 frequency on channel 3, etc.).
This is apparently happening in the PC, as the mistake was copied into all of the radios.
We fixed the glitch, reprogrammed them a second time, and it did it again. On the third try, they stayed as they should have.
This is in VHF high band conventional, with 6 zones programmed. The other zones were left correct.
We've seen this in other XTS2500's, but to a lesser extent, such as a PL on one or two channels being wrong. Up til now, we've written it off as fat fingers, and some of those might be, but this can't be a typo, it's too extensive.
Anybody else seeing this?
This is apparently happening in the PC, as the mistake was copied into all of the radios.
We fixed the glitch, reprogrammed them a second time, and it did it again. On the third try, they stayed as they should have.
This is in VHF high band conventional, with 6 zones programmed. The other zones were left correct.
We've seen this in other XTS2500's, but to a lesser extent, such as a PL on one or two channels being wrong. Up til now, we've written it off as fat fingers, and some of those might be, but this can't be a typo, it's too extensive.
Anybody else seeing this?