Batboard

Our GR1225 has been working for over a year, but recently it has started recycling rapidly, 1 sec on, 1 sec off. I checked the duplexer tuning and it is fine. I looked at the programming and it has not changed. All cables are plugged in and have been reseated.

Any ideas on what may be causing this?

Thanks,
-gene

Power supply?

I don't think so, I did lower the power and it stills cycles. But it's a good thought and I will check it out.

Thanks!

BINGO!

It was the power supply. Under load, it cuts in and out.

Thanks so much, Bill!

-gene