Batboard

hi everyone, ive searched the site and havent seen anything that addresses my question.

i have a GR300/GR400 Repeater with 2 GM300 mobiles.
the mobiles are programmed with the correct accy pins and it does receive and transmit as it should.
the RX mobile is programmed with 103.5 RX pl and the TX radio is programmed with 103.5 PL

it will rx and rebroadcast what it hears on the input to the output as any normal repeater would, the only issue is, theres no TX pl, even tho the mobile is programmed with it.

i dont see any option in the ZR340 setup manual to affect pl, or atleast not in common terms.

i have tried 2 TX mobiles, and 3 ZR340 controllers, they all work the same, repeat fine, no TX pl.

ive even reset the controllers to factory default....


any ideas????

Do they transmit PL when you key them with a microphone?

Make sure the jumpers in the RX and TX radios are setup properly according to the GR300-500 service manual. Also go over the ZR340 setup procedure in the service and RSS manuals and make sure you didn't miss anything.