Batboard

I found programming instructions online for this ZR310, but can't seem to make this box do what it needs to do.

Anyone got some chops programming one of these panels? I want the BSID to go out without CTCSS. The tx radio is programmed for TX CDCSS, but I can't seem to figure out how to make the panel generate the cdcss and get it to broadcast the BSID without it.

Any help would be greatly appreciated.

TY

Semper Fi

Late reply but it is not physically possible to do PL-stripped CW ID with the setup you have. The controller has no way of telling the radio to not encode its transmit tone, and the radio has no way of enabling/disabling tone transmit from rear accessory connector logic. Sorry.

To do PL-stripped CW ID you need a real repeater (Quantar, GTR, SLR, TKR-x40/x50, etc.)