Batboard

I am trying a simple task of tuning my IFR 2975 to pick up an FM radio station. I can see the signal being transmitted at 101.5 mHz but cannot get it to demodulate to give me audio out of the speaker. Will kick myself I am sure but what am I missing? I do get the carrier noise but no audio.

using antenna port
RX set to FM
demod audio
generators off
FM output off


Thanks ahead of time

Typically FM radio stations transmit about 100khz wide and the typical
FM setting in a service monitor is about 5Khz so you are most likely
not getting enough of the modulation to decode.

Thanks to fineshot1 appreciate the response.

No problem - you are welcome but i must stress that i am guesstimating in my response.