TKN8531C KVL Loader Cable for Systems Saber How to DIY?
Posted: Sat Jun 18, 2016 2:19 pm
I need to build a cable to load my Systems Saber from my KVL. I have the NTN5664D Hirose adaptor and a Hirose 6P mating plug. Now I need to modify one of my existing but obsolete KVL cables to match the pins on the Hirose adaptor.
Yes I have been to the bat labs site (below) and I don't see a TKN8531C which is what I understand is required but I see an EXPO TKN8351 (note transposed digits) on Bat Labs site. Also the KVL manual shows a TKN8531B cable for EXPO that is quite different in that it has an additional wire and 1K resistor.
I am thinking the TKN8531B cable is closer to what I need to build, but what differentiates a B from a C?
So before I melt solder could someone please provide me pin outs for an TKN8531C cable?
KVL Pinouts
Thanks
Yes I have been to the bat labs site (below) and I don't see a TKN8531C which is what I understand is required but I see an EXPO TKN8351 (note transposed digits) on Bat Labs site. Also the KVL manual shows a TKN8531B cable for EXPO that is quite different in that it has an additional wire and 1K resistor.
I am thinking the TKN8531B cable is closer to what I need to build, but what differentiates a B from a C?
So before I melt solder could someone please provide me pin outs for an TKN8531C cable?
KVL Pinouts
Thanks