XTL5000 High power and Quick call II Vmute issue.
Posted: Tue Jan 23, 2018 5:29 pm
Thanks for looking:
I have poured over the forums and no resolution.
I have a local agency that still uses QCII and i am trying to figure out where i am going wrong with the Voice Mute funciton.
1: Agency is using custom 1Sec by 3sec tones, and as far as i know, NO PL or DPL. (Standard A/B format)
2: Conventional Profile is set receive only, Signaling, QCII, and both Call Alert and In-call are enabled.
3: The radio will detect the tone, and will display Page received and audibally alert and open the squelch when NOT in Vmute.
4: Where the problem comes in: When in Vmute, the radio recognises the tones, visually/Autibally alert,.. the speaker shows open, but the radio will not pass the audio until Vmute is disabled.
(Dont know if it makes a difference, but there is no break in the transmission transitioning from tone to dispatch.) The radio remains muted even after the time out although the speaker does not show muted.
I have tried ALL unmute/mute settings, Sel call/In-call reset settings. The recive only profile is NON-Astro.
Firmware, R20.50.05
DSP: R19.50.01
Codeplug 0024
M20KTS9PW1AN
Flashcode: 580088-801480-6
Any Suggestions?
Appreciate it.
Radar
I have poured over the forums and no resolution.
I have a local agency that still uses QCII and i am trying to figure out where i am going wrong with the Voice Mute funciton.
1: Agency is using custom 1Sec by 3sec tones, and as far as i know, NO PL or DPL. (Standard A/B format)
2: Conventional Profile is set receive only, Signaling, QCII, and both Call Alert and In-call are enabled.
3: The radio will detect the tone, and will display Page received and audibally alert and open the squelch when NOT in Vmute.
4: Where the problem comes in: When in Vmute, the radio recognises the tones, visually/Autibally alert,.. the speaker shows open, but the radio will not pass the audio until Vmute is disabled.
(Dont know if it makes a difference, but there is no break in the transmission transitioning from tone to dispatch.) The radio remains muted even after the time out although the speaker does not show muted.
I have tried ALL unmute/mute settings, Sel call/In-call reset settings. The recive only profile is NON-Astro.
Firmware, R20.50.05
DSP: R19.50.01
Codeplug 0024
M20KTS9PW1AN
Flashcode: 580088-801480-6
Any Suggestions?
Appreciate it.
Radar