Com120C receive level set
Posted: Thu Jan 10, 2019 9:31 pm
When in receive, zoomed on the receive level screen there is an option to set level.
Whenever I follow the prompt to put a jumper from TR to antenna, I see the calibration happening, BUT
After, the receive bar graph shows full, even with no signal.
Restoring to defaults from the main menu clears this.
Anyone actually have this work?
TIA
Whenever I follow the prompt to put a jumper from TR to antenna, I see the calibration happening, BUT
After, the receive bar graph shows full, even with no signal.
Restoring to defaults from the main menu clears this.
Anyone actually have this work?
TIA