Batboard

Hi all!

What is the easiest way to keyup Nucleus? It mist be some way to set it in TX mode. This unit is VHF TX (regular 100W version) with UHF2 RX module installed.

ACM is set to default setting.

I can supply RF carrier of any frequency, AF signal or POCSAG transmission if needed.

Thanks!

Have you read this? Might have some useful pointers:

http://www.repeater-builder.com/motorol ... ticle.html

Yes, but I am not looking for any HW mods. I want to key it up by some native way. Like sending a transmission on 'link' frequency (they usually were around 458 MHz) in my area.

Nucleus cannot be keyed that way while running in simulcast mode.