Page 1 of 1
Posted: Thu Nov 22, 2001 12:51 pm
by mobiletechcom
need help here guys,, i have a syntor x9000 system with a dtmf mic and i cant get the Pl to work on the recieve side. i have the mic cradle grounded and checked the micro swith on the back of the mic and still no luck,,,any help will be great..thanks,, happy thanksgiving
Posted: Thu Nov 22, 2001 1:21 pm
by Jack
Howdy, I don't know what kind of microphone you have but mine has a small button on the back. If this button isn't pushed all the way in, receive pl won't work, even with monitor off because the radio is supposed to go into the monitor mode when lifting the mic. This mic isn't like the maxtrac, GM300 etc, which uses ground on the cradle. The one on my radio is definately done with the button on the back of the mic. Good luck. I hope you're able to find the problem.
<font size=-1>[ This Message was edited by: Jack on 2001-11-22 16:22 ]</font>
Posted: Fri Nov 23, 2001 4:28 pm
by mobiletechcom
i checked the switch and its working fine...any other ideas?
Posted: Fri Nov 23, 2001 7:15 pm
by streaker
Try pressing the "SQL" button on the numeric portion of the keypad. I haven't checked mine to be sure this is correct, but, a short press should say monitor off or monitor on, be sure it is set to monitor off for PL's to work properly on receive.
Posted: Sat Nov 24, 2001 7:09 am
by FDNY
hi,,
it's possible that you have a defective PL board...from what you say the decode is malfunctioning...is this on all channels
good luck................
Posted: Sat Nov 24, 2001 7:59 am
by Jack
In addition to what streaker said, I had a bad mic one time and the receive pl wouldn't work even with the small button on the back pushed in. If you can get your hands on another mic, try that. That solved my problem. Good luck.
Jack