Page 1 of 1
Posted: Wed Nov 28, 2001 9:47 am
by wm4t
When programming a msf5000 I had a voltage on the 9volt battery connector of the rib, is this normal? I took the battery off and programmed the unit with no problem. Never seen where your supposed to remove the rib battery. Any comments on this?
Posted: Wed Nov 28, 2001 9:19 pm
by Al
Two ways to program the MSF...one is through the 40 pin connector on top of the RF tray using a Mot(or built) cable. The Mot cable has a line included to supply DC power to the RIB, so you don't need a RIB battery if you use this method. Other method is to program through the 6 pin control modular connector on front of the RF tray. In this case, you do need battery or AC power supply on the RIB.