Page 1 of 1
Posted: Thu Dec 20, 2001 3:55 pm
by Jay G.
Hello all. I am trying to get my Maxtrac 300 to user scan more then the first 16 channels. I only have 10 in the list, but it wont accept any channel over 16 into the list. Also applies if I have the regular scan list programmed to scan.... any ideas???
Posted: Thu Dec 20, 2001 6:04 pm
by raymond345
What ver. motorola RSS are u using?
What number of channels can u setup?
Raymond eMail
[email protected]
Posted: Thu Dec 20, 2001 6:34 pm
by Jay
I know that I have had this problem before with hacked 16 channel rigs that were made in 32 channel radios. In this case, it will only let you scan modes 1-16.
Jay
Posted: Sat Dec 22, 2001 11:17 pm
by Jay G.
I dont have RSS - My friend who works at a dealer programmed it for me. as far as i know it is a legit 32 channel radio. When he programmed it, it accepted 19 channels into scan with no problem. When I tried it at home, it doesnt work. I even tried to enable them as a user scan list, but it wont let me. Any ideas??
Thanks