Batboard

I am trying to find out what settings you need to change scanlists when you change zones. I understand that it shoud work like this, but it doesn't seem to.

Scanlists are chosen in each conventional or trunking mode. It should be a tab on the top of the page in the mode setup. Also, once you active scan in the mode, you have to go to the scanlists in the scan tab near the bottom and setup each scanlist. FatBoy.

You can email me the codeplug, but i only have the newest software. If you dont have the newest, I may be able to walk you through on the fone. FatBoy