Page 1 of 1
Posted: Sun Jan 06, 2002 6:35 pm
by parsoons
I have a low band syntor 9000 that receives fine, transmits, but no audio comes across. Used radio just programming. I had a similiar problem with another one, but would not transmit at all, it was fixed by changing tx inhibit. Any thoughts?? I would think something in the programming needs to be changed from where it was set previously. No errrors codes.
Bob
Posted: Sun Jan 06, 2002 6:43 pm
by Pj
Check the pins on the J1 connector. I have a x9000 that does that when there isn't enough pressure on the pin. Because of that, it doesn't make electrical contact. I find if I twist a little bit, it works and stays in place.
Yeah yeah, I know, I should fix it, but I haven't had the time yet!
Posted: Sun Jan 06, 2002 7:13 pm
by xmo
There won't be any mic audio while you still have the program cable hooked to it.
Posted: Mon Jan 07, 2002 12:16 pm
by parsoons
Thanks for the info. I boneheaded tried it with the program cable still attached.... Need to refresh myself sometimes.
Bob