Page 1 of 1
Posted: Thu Jan 10, 2002 7:26 am
by alex
I'd like to replace the control head on my maxtrac - I used to have the part number somewhere, and don't remember it being terribly expensive ($20-$30).
I believe there is a part # for the whole assembly -- stickers, plastic, volume knob, whole 9 yards...
-Alex
Posted: Thu Jan 10, 2002 9:18 am
by Max-trac
It is HCN3217B for the full featured conventional. Not sure on the 800trunking, but it just has a diffent escution. The 900Mhz is FCN1603D, it has a different volume-pot board (hear-clear?)
Posted: Thu Jan 10, 2002 10:12 am
by alex
Cool,
Thanks!
Posted: Thu Jan 10, 2002 1:25 pm
by Will
What is the head part number for the Radius M200 series?
Posted: Thu Jan 10, 2002 5:51 pm
by Max-trac
I have a radius full featured front labeled;
HCN3297A I am pretty sure it is the same electronically as the Maxtrac, just has a different "look"......
Posted: Fri Jan 11, 2002 7:53 pm
by Will
The boards in the heads are the same but the outer housing is different on the Radius radios.
And thanks for the part number.
Posted: Fri Jan 11, 2002 8:16 pm
by alex
I ordered two of these kits, I'll let people know how they come on Monday/Tuesday...
-Alex
Posted: Mon Jan 14, 2002 12:04 pm
by alex
*bump*
Well, I got the heads, they look quite nice.. However, I'm missing the sticker that goes over the numbers...
Can I have the part number for that? Or was I supposed to get it as part of the kit?
-Alex
Posted: Sun Jan 20, 2002 5:38 pm
by Max-trac
Sticker over numbers????
I have an eschution (sp?) that has the number; 1380277l01 on it. It is the conventional one. If you are looking to replace the Motorola maxtrac 800 in the lower right corner, I don't know...