Page 1 of 1
Posted: Tue Jan 15, 2002 5:51 am
by AS3 Beginner
While I switch on my Radio the display show ERROR 09.
Then I press [DATA] button it shows [LCD TEST], while I press [Home] show [KEY TEST].
then show [06 01 -- --]
I do not know what happens and the LCD display Light is flashing then stop.
Posted: Wed Jan 16, 2002 2:54 am
by Monty
Hi:
Well, I hate to be the Bad Guy, but
I have seen that all to often. What
has happen is you have corrupted the
Pirmary Code Plug.
I can restore them at less than 1/2 of what
Motorola charges if you desire. I have many
persons with Sabers as a reference if you
need them
Also, you need a Stable 386-486-25 Computer
Platfom ( running real DOS ) along with a Good Rib Box ( Motorola Prefered ) and a good program Cable.
Its also advised to have a Fresh Battery, Power Supply for the Rib, and a UPS for the
Computer....
With the above set up, corrupted code plugs
dissapear forever !
Monty
Posted: Wed Jan 16, 2002 8:13 am
by AS3 Beginner
Many thanks your reply.
I have the RIB, Cables, RSS and a 486 computer.
Do you meant that I can fix by may self ?
If you have any information or reference how to fix the Radio could you share with me and I am very appreciate.
Many thanks again !
AS3 Beginner
Posted: Wed Jan 16, 2002 10:57 am
by patrol186
You could try to build a fresh codeplug using the correct model # and options and try to dump it in a few times I was able to recover one that way
might be worth a try
Posted: Wed Jan 16, 2002 11:15 am
by Monty
Hi:
Sorry to report, when you have a " Flashing"
Display, that is pretty much the End.
( period )
Unortunitely it requires a Special Jig ( I have made one ) to alow access to the PC board while under tests.
To complex to describe, and I will not want
to take the responsibility of try to give
the proceedures out, and have a person make
their radio even worse.
The problem is you may ( highly ) probable
you have damaged the CORE...Once that happens
the radio will no longer Read or Write, and
the Display Will Flash.
It truly does take a test fixture to fix.
Its the Internal CORE must be re-established.
MS
Posted: Thu Jan 17, 2002 11:18 am
by 10-95
I have had the same problem from time to time , make sure you have a fresh battery in the rib, then create a new code plug with the proper model numberfrom the create codeplug function in the rss, now load it in.
You will have to go into the service menu to re-align the radio, as all your current settings are most certainly gone now.
10-95