Batboard

OK, does anyone have any info on the pin outs on these. Mine is set up like this...
The round connector has six connections in a circle. The radio connector part has 9 pins and looks like this if looking at the connector pins on the hi-rose
00 O <---- antenna pins and mount screw.

x 0 0
x 0 0
0 0 0
x 0 0

x= no pin

The top of the seal cap shows a pair of head phones. I'd like to build an adapter to interface a neweagle tactical head set to this but I don't have any schematics or pin outs. If anyone can help with the literature or details I would appreciate it and would try to make it worth your time.


Thanks.

Is this an adaptor used on the Saber radios?
Most of them had the standard HiRose connections to match many accessories that have the HiRose ala EXPO radio accessory connector.

I make adaptors that go in-between the HiRose and your tac headset connector.

Hi Will, that's what I was trying to do but it's a pain becase the head set has a bendix king plug on the end and I can't hack it off since it belongs to the department.
What I was needing was a pin out diagram for the hi rose connector I guess. I took the side jack parts off an old bendix/king and made a female adaptor to plug the head set into. I now need the part # for the plug that goes into the HI-ROSE and a wiring diagram.


later.

Check out these websites for help:

Hirose Electric: The connector is one of the HR10 series. They make panel mount & inline males and females. They have a pdf catalo with all the specs and part numbers.
http://www.hirose.com/hiroseusa.htm

Digikey: Distributor for Hirose, stocks a lot of stuff.
http://www.digikey.com/

Hirose / Expo Schematic: Thanks to msisco9939 http://batboard.batlabs.com/viewtopic.p ... 89&forum=1

I used all these sources for a Hirose to Jedi adapter I made.

Hope this helps

Jim Brissie

<font size=-1>[ This Message was edited by: jimbrissie on 2002-01-23 09:39 ]</font>