Page 1 of 1
Posted: Wed Jan 23, 2002 2:42 pm
by john6458
I AN TRYING TO PUSH MY SABER1 OUT OF BAND AND CAN NOT GET IT TO WORK. I DOWN LOADED ALL OF THE PROGRAMS ON BATLABS. AND THE RSS WILL NOT LET ME PROGRAM IT TO THE RADIO. THE RSS SAYS BAD FILE. NOW IT IS ONLY 3MHZ OUT OF BAND . I EVEN COPYED OUT OF A RADIO IN THE RIGHT BAND CODES . DOES AND ONE KNOW OF A EDIT PROGRAM THAT WILL WORK.
Posted: Wed Jan 23, 2002 2:56 pm
by Tom in D.C.
John: If you're trying to go 3 mHz out of band ("Band" being the standard range of the radio) you probably won't be able to do so. You can probably do 1 mHz plus or minus a little, but not 3 mHz. RSS editing won't help, because the limitations are caused by the firmware in the radio as it was built.
Regards,
Tom, W2NJS
...in D.C.
Posted: Wed Jan 23, 2002 2:59 pm
by 10-95
1mhz is probably about it , unless you have some knid of hybrid synthesizer in that radio, but I doubt it.
Frank