Page 1 of 1
head light flasher 94 Early 90's exploder
Posted: Fri Jan 30, 2004 5:44 am
by KitN1MCC
i am going to install a head light flasher n a the exploer there older squar ranger body style.
i know what colors i need were should i tap into the harness on the driver or passanger side
Posted: Fri Jan 30, 2004 6:21 am
by nmfire10
I usually unplug the harness from the light and do the splicing on that section of wire. You should have about a 7" of wire to work with and you can pull back the loom to get more if needed.
Posted: Fri Jan 30, 2004 7:05 am
by FFParamedic571
I think all fords are the same Green with black at the plug on the back of the headlight..
Posted: Fri Jan 30, 2004 7:14 am
by jim
Um......turn the high beams on. Take a test light and stick it into the three pins. One will light with the high beam switch on. This is the high beam wire!
Posted: Sat Jan 31, 2004 1:23 pm
by KitN1MCC
i am installing whelen flasher and need to break the wire liek the directions that come with the flasher , inned to knwo were to make the break
Posted: Sat Jan 31, 2004 4:35 pm
by jim
at the headlight. solder & shrinktube!