Hi,
How to setting communicate Saber between Astro using DES encryption ?
I have Astro Saber w/secure module(DES-XL) and Saber w/secure module(DES-XL).
Setting.
Astro
Secure Hardware Equipped..Yes
Rx Voice/Signal Type..Non-ASTRO
Tx Deviation..5.0kHz
Secure Voice/Signal Type..Securenet
Key inserted via KVL3000.
But, no modulation transmit.(carrier only)
Help!!
How to communicate Saber between Astro using DES encryption.
Moderator: Queue Moderator
Hello,
I had a similar problem with a VHF saber securenet and an VHF XTS3000 and while I'm still analyzing it, I was able to make them talk by turning XL off. When I find the time I plan to get back to it and find out why when both radios were set to des-xl the xts3000 could decode the saber but the saber didn't decode the xts3000 but once XL was shut off both radios worked as they should.
And yes I'm sure both radios have xl encryption in them, at least I know 100% that the XTS3000 has but I'm not 100% sure about the saber, I'll check it more in depth when I get the time.
Mike
I had a similar problem with a VHF saber securenet and an VHF XTS3000 and while I'm still analyzing it, I was able to make them talk by turning XL off. When I find the time I plan to get back to it and find out why when both radios were set to des-xl the xts3000 could decode the saber but the saber didn't decode the xts3000 but once XL was shut off both radios worked as they should.
And yes I'm sure both radios have xl encryption in them, at least I know 100% that the XTS3000 has but I'm not 100% sure about the saber, I'll check it more in depth when I get the time.
Mike
Mike,
I have SABER III UHF. My SABER setting is XL enable..N.
and I have two secure module for ASTRO(DES-XL/DES-OFB,DES-XL/DVP).Although I exchanged these modules, I was changeless.
It is a setup of ASTRO that I want to ask you.
<img src="http://rose.zero.ad.jp/~zad56159/Mot/1.png">
<img src="http://rose.zero.ad.jp/~zad56159/Mot/2.png">
<img src="http://rose.zero.ad.jp/~zad56159/Mot/3.png">
<img src="http://rose.zero.ad.jp/~zad56159/Mot/4.png">
<img src="http://rose.zero.ad.jp/~zad56159/Mot/5.png">
I have SABER III UHF. My SABER setting is XL enable..N.
and I have two secure module for ASTRO(DES-XL/DES-OFB,DES-XL/DVP).Although I exchanged these modules, I was changeless.
It is a setup of ASTRO that I want to ask you.
<img src="http://rose.zero.ad.jp/~zad56159/Mot/1.png">
<img src="http://rose.zero.ad.jp/~zad56159/Mot/2.png">
<img src="http://rose.zero.ad.jp/~zad56159/Mot/3.png">
<img src="http://rose.zero.ad.jp/~zad56159/Mot/4.png">
<img src="http://rose.zero.ad.jp/~zad56159/Mot/5.png">