Page 1 of 1
Posted: Fri Feb 22, 2002 4:39 pm
by bundy125
Using your RICK, is it (1) possible to Xband a 16 pin M-208 low band & 5 pin maxtrac VHF, & (2) when it is not necessary, use both radios independent of each other. I may have asked you this question before, but my hard drive crashed and I lost all my personal emails. Thanx in advance
Posted: Fri Feb 22, 2002 5:07 pm
by metro121
bundy125
I just posted a reply on the exact setup you are questioning.
It was originally posted by joeS31.
It should answer your question.
Posted: Fri Feb 22, 2002 5:15 pm
by bundy125
Thanx
Posted: Fri Feb 22, 2002 5:20 pm
by Will
Yes, this because there is a disable switch that completely disconnects the radios. And Yes each radio will work just like it never had my module plugged in (the module stays plugged in).
Posted: Fri Feb 22, 2002 5:43 pm
by bundy125
Will, could you email me and give me the cost of the cable and if there are any retrofit issues?
Posted: Fri Feb 22, 2002 6:08 pm
by Will
The module is hand made for the type of logic boards involved. They cost 125 including radio mods for five pin logic boards.
Send PM and I can give further info.