Page 1 of 1
Posted: Fri Feb 22, 2002 8:59 pm
by kcm
I try to program my saber III and accidently program code plug AN into my CN radio. It show ERR 0 C1 on display. How to solve this error? The old code plug show version H43QXK7139CN. RSS version R05.00.00
<font size=-1>[ This Message was edited by: kcm on 2002-02-23 00:01 ]</font>
Posted: Fri Feb 22, 2002 9:59 pm
by N4UMJ
This is saying that your "CORE" (transceiver microprocessor) has an internal EEPROM checksum error.
My Saber Programming manual says to try several attempts at reprogramming it. Then it says the microprocessor must be changed.
"MONTY" on the forum here has a great amount of experience from what I have seen in dealing with these type of problems.
Hope you were using the correct speed computer and software?
I use an older 386 IBM DOS machine and it works well.
Ed
N4UMJ
Posted: Fri Feb 22, 2002 10:21 pm
by kcm
First time I use 486 PC with 80MHz. Now I set jumper on main board to 50 MHz but nothing change. It's still error.
Thank you anyway.
Posted: Sat Feb 23, 2002 6:31 am
by Monty
Hi:
Look at you email !
I sent a List of things to check
Monty
Posted: Sat Feb 23, 2002 8:09 am
by kcm
Thank you very much for both Ed and Monty. The problem was solved. First time I use RSS R05.00 and get an error. After change to R07.01.00, the radio was back to normal.
Posted: Sat Feb 23, 2002 12:54 pm
by N4UMJ
Hello KCM,
Glad to hear it wasn't a worst case
scenario and you succeded!
Ed
N4UMJ